Drive wheel / drive shaft measurement

Drive wheel measuring device / measuring station pneumatic – electronic measuring technology

Measuring station for different variants of the drive wheel with a combination of pneumatic – electronic measuring technology. The operator can quickly switch the measuring station to the different drive wheel heights by adjusting the measuring units.

The component is placed on the pre-storage and after leaving the light curtain, the measuring sequence is started automatically. The measuring air is switched on, the drive wheel is lowered, and the centre point is closed. The measuring unit is fed in and the rotary drive is started after the measuring probes have been fed in. Dynamic measurement takes place and after evaluation the measurement results are displayed on the screen and stored on the computer. The measuring units are reset, the rotary drive and measuring air are shut off and the drive wheel is raised for removal.

Calibration is done manually via Setting Master MIN. The calibration time can be freely set in the software. After the request, the setting master is placed on the pre-storage. The measuring device recognises the setting master and the calibration cycle is carried out automatically. After removal, measurement can be continued.

Drive shaft measuring automation / measuring station – pneumatic measuring technology

Drive shaft measuring automation for different variants of the output shaft. The operator can quickly convert the measuring station to the different drive shafts by means of exchange units and the adjustment of the tailstock, headstock and resetting device.

The drive shafts are placed on the pre-storage via the gantry loader of the processing machine; after leaving the protected area, the measuring sequence is started automatically. The measuring air is switched on, the centre point and the measuring slide are fed. After starting the rotary drive, the dynamic measurement is started. After evaluation, the measurement results are displayed on the screen, stored on the computer and output at the interface. The measuring units are reset, the rotary drive and measuring air are shut off, and the drive shaft can be taken over by the gantry loader.

Calibration is carried out automatically via Setting Master MIN. The calibration time can be freely set in the software, after the request the gantry loader places the Setting Master on the pre-storage and the measuring unit recognises the Setting Master and the calibration cycle is carried out automatically. After removal by the gantry loader, measurement can continue.