Other gear parts

Enclosure measuring device / measuring station, electronic measuring technology

Measuring station for enclosures with electronic measuring technology. The component is placed on the pre-storage and pressed against the end stops. The measuring sequence is started automatically when the component leaves the light curtain. The component is lifted into the measuring position against the reference points and the measuring probes are fed. Static measurement takes place and after evaluation the measurement results are displayed on the screen and stored on the computer. The measuring probes are reset and the component is lowered for removal.

Calibration is done manually via Setting Master MIN. The calibration time can be freely set in the software. After the request, the Setting Master is placed on the pre-storage, the measuring device recognises the Setting Master and the calibration cycle is carried out automatically. After removal, measurement can be continued.

Housing Measuring device for a quick check of the unmachined parts with dial gauges.

The component is placed on the pre-storage and pressed against the end stops. By turning the hand lever (right or left), the component is lifted into the measuring position against the reference points. The measured values can be read off the individual dial gauges. After turning back, the component is lowered for removal.

The setting and checking of the measuring device / dial gauges is done manually via setting master MIN / MAX. The setting master is placed on the pre-storage and lifted into measuring position against the reference points by turning the hand lever. The settings can be checked or adjusted; after removal, measurement can continue.