Home - Complete solutions - Projects - Chassis parts - Front axle shaft
Due to the special design of our pneumatic measuring technology, we can offer you a measuring device with higher stability and accuracy here.
Front axle shaft measuring device / measuring stations with fixed measuring mandrels for maximum stability. Due to the large measuring range of the individual nozzles, a large undersize of the measuring body can be achieved, so that even larger tolerances from shape and position can be taken into account and the components can be fed even more easily. By means of linearisation, small tolerances in the bores can be measured with optimum accuracy at the same time.
The base is designed so that similar groups of components can be measured here by safely and easily changing the individual measuring units.
Front axle shaft measuring device / measuring station pneumatic – electronic measuring technology
Measuring station for different variants of the front axle shaft with a combination of pneumatic – electronic measuring technology and pneumatic manual measuring mandrel. The operator can quickly adjust the measuring station to the different heights of the front axle shafts by moving the measuring units.
The component is placed on the pre-storage and after leaving the light curtain, the measuring sequence is started automatically. The measuring air is switched on, the front axle shaft is lowered, and the centre point is closed. The measuring unit is fed in and the rotary drive is started after the measuring probes have been fed in. The static measurement takes place and after evaluation the intermediate results are displayed on the screen. The front axle shaft is lifted and the manual measurement with the measuring mandrel is carried out. After the measured value has been accepted, the measuring air is switched off, the final result is displayed on the screen and stored on the computer. The front axle shaft can be removed.
Calibration is done manually via Einstellmeister MIN. The calibration time can be freely set in the software. After the request, the Einstellmeister is placed on the pre-storage, the measuring device recognises the Einstellmeister and the calibration cycle is carried out automatically. After removal, measurement can be continued.
Van Dongen Engineering Dorser 1, Someren The Netherlands
+31 493 - 490 234 Send email
More information. Do you need more information about a specific product or topic? Then you can fill out this document and send us your question(s). We thank you for your trust and would be pleased to support you in solving your task.
Please read in our Privacystatement how we process the data from this form.
Keep an eye on our website and LinkedIn