Home - Complete solutions - Projects - Gear parts - Drive wheel / drive shaft
Due to the special design of our pneumatic measuring technology, we can offer you a measuring device with higher stability and accuracy here.
Drive wheel / drive shaft measuring device / measuring stations with permanently installed measuring mandrels for maximum stability. Due to the large measuring range of the individual mandrels, a large undersize of the measuring body can be achieved so that larger tolerances from shape and position can also be taken into account and the components can be fed even more easily. By means of linearisation, small tolerances in the bores can be measured with optimum accuracy at the same time.
The base is designed so that similar groups of components can be measured here by safely and easily converting / rearranging the individual measuring units.
Drive wheel measuring device / measuring station pneumatic – electronic measuring technology
Measuring station for different variants of the drive wheel with a combination of pneumatic – electronic measuring technology. The operator can quickly switch the measuring station to the different drive wheel heights by adjusting the measuring units.
The component is placed on the pre-storage and after leaving the light curtain, the measuring sequence is started automatically. The measuring air is switched on, the drive wheel is lowered, and the centre point is closed. The measuring unit is fed in and the rotary drive is started after the measuring probes have been fed in. Dynamic measurement takes place and after evaluation the measurement results are displayed on the screen and stored on the computer. The measuring units are reset, the rotary drive and measuring air are shut off and the drive wheel is raised for removal.
Calibration is done manually via Setting Master MIN. The calibration time can be freely set in the software. After the request, the setting master is placed on the pre-storage. The measuring device recognises the setting master and the calibration cycle is carried out automatically. After removal, measurement can be continued.
Drive shaft measuring automation / measuring station – pneumatic measuring technology
Drive shaft measuring automation for different variants of the output shaft. The operator can quickly convert the measuring station to the different drive shafts by means of exchange units and the adjustment of the tailstock, headstock and resetting device.
The drive shafts are placed on the pre-storage via the gantry loader of the processing machine; after leaving the protected area, the measuring sequence is started automatically. The measuring air is switched on, the centre point and the measuring slide are fed. After starting the rotary drive, the dynamic measurement is started. After evaluation, the measurement results are displayed on the screen, stored on the computer and output at the interface. The measuring units are reset, the rotary drive and measuring air are shut off, and the drive shaft can be taken over by the gantry loader.
Calibration is carried out automatically via Setting Master MIN. The calibration time can be freely set in the software, after the request the gantry loader places the Setting Master on the pre-storage and the measuring unit recognises the Setting Master and the calibration cycle is carried out automatically. After removal by the gantry loader, measurement can continue.
Van Dongen Engineering Dorser 1, Someren The Netherlands
+31 493 - 490 234 Send email
More information. Do you need more information about a specific product or topic? Then you can fill out this document and send us your question(s). We thank you for your trust and would be pleased to support you in solving your task.
Please read in our Privacystatement how we process the data from this form.
Keep an eye on our website and LinkedIn